"Why do I need an AquaBoost traditional cold water boost pump set?"
If the property has specific flow rate and pressure requirements to meet peak demand.
If the pressure requirement for the property is greater than 4Bar due to either the height of the property or specific pressure requirements of equipment to be installed.
If a MainsBoost™ Water Performance System is unsuitable for the application.
"When should I install one?"
When there is insufficient water pressure and flow rates to meet the demands of the property but the specification calls for the more traditional water boosting solution.
The AquaBoost when used in conjunction with a PureStor GRP cold water storeage tank provides a packaged WRAS approved water boosting solution to meet the needs of most large domestic and commercial applications.
"How Does it Work?"
standard range of single and twin pump models have a flow rate of 60-120lpm and outlet pressure of up to 4.8Bar to deliver improved water performance by boosting water pressure throughout the system.
Pressure and flow are controlled via a pressure transducer and user friendly interface EMT electronic control for ease of use and setting performance parameters. Motors are Aluminium 2-Pole (2900rpm) induction motors, 230V-50hz, class F insulation, IP54 enclosure, IEC34.
Twin pump models are mounted on a galvanised base and fitted with stainless manifolds with brass valves and fittings, PressureWave™ vessel and pressure gauge and are supplied inclusive of suction/discharge anti vibration couplings and base mounts.
All standard units are supplied 240 volt single phase.
Maximum water temperature 50°C.
technical information click here